![]() General proportion is – 16 oz of the Fresco Plaster Weld to 4 quarts of Arriccio Fresco Painting Plaster (ratio 1 part “Colonial Fresco lime Putty” to 2 parts sand). You can refer to the instructions on the plaster weld paint container, as their instructions may change over time, or call the technical department number also listed on container. If you do not need prime with oil you stand chance of delamination /peeling. The next day paint everything with latex paint right over the Plaster-Weld, the latex paint will stick to it just fine. Rough up the old paint and roll Plaster-Weld over the whole bathroom. ![]() Now put your plaster mixed with sheet rock compound into big holes and cracks. ![]() NOTE: Fresco Plaster Weld is added ONLY to Base Coat/Layer! Prime the plaster weld first, to establish this bond, then paint the acrylic paint. Bonds new plaster to any clean, structurally sound, interior surface. Scrap the big pieces off, put Plaster-Weld in the big holes with a paint brush. Just the same way you would add water minutes before the application to soften the mix – and applied to pre-painted (drywall) walls or primed plywood/wood panels (2 coats of commercial primer or paint).įor installing to pre-painted Drywall or Primed Panel You will need to have 3 Coats/Layers (allow plaster to fully cure, between applying coats): The Plaster-Weld original plaster bonding agent is a patented formulation incorporating polyvinyl acetate homopolymer. Plaster-Weld® may be painted over painted surfaces provided the paint is still well secured to the substrate. Ever wondered how to apply fresco painting plaster over painted drywall or wooden panel?įresco Plaster Weld is added to the Base Coat/Layer (mix-ratio 1 part lime to 2 parts sand) right before application during plaster conditioning instead of water.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |